Rola 59403 Manual De Instrucciones página 2

Please read all instructions carefully before assembly, installation and/or use of this product.
LOADING INSTRUCTIONS:
1. Place the bike rack receiver into your receiver hitch. Fit rack as close to vehicle as possible.
2. For 2" hitch, secure rack with 5/8" hitch pin and clip.
For 1-1/4" hitch, secure rack with ½" pin and clip
(See Diagram 2 & 4)
Note: Must use the second or third hole 1-1/4" shank to secure bike rack to hitch.
1. The bikes are loaded onto the rack alternating each bike, with the anti-sway cradle being closest to the seat tube.
(See Diagram 5)
2. Secure the bikes by pulling the bungee straps over the top of the bike frame. The anti-sway straps wrap around the
seat tube prevent the bike from swaying.
3. Check the bungee straps periodically and after stopping to insure that they are still tight and that someone has not
released them. NOTE: Insure all locks are locked, that all pins are secured, and that all bungee straps are properly
attached prior to moving the vehicle. Failure to do so will void the warranty.
Install 5/8" pin and clip for 2" hitch
Install ½" pin and clip for 1-1/4" hitch
INSTRUCTIONS FOR FOLDING THE RACK:
1. Insert the key into the lock mechanism and turn to release the lock pin.
2. Pull support tube firmly upwards until lower pin slides to the top of its slot.
(See Diagram 6)
3. Lower the tube slowly back until support tube rests on the stop plate.
NOTE: Do not drop or let the support tube fall freely. Make sure that your
hands and fingers are clear of the hinging area during this operation.
4. To restore the rack to the upright position, do reverse procedure.
Remove the key from the lock and push the center of the cylinder in to
engage the lock pin. A notable click will indicate that the pin is locked.
5. Check periodically to insure you have a solid fit between the rack and the
mounting location
Cequent Towing Products - Plymouth, MI
Technical Service: (888) 521-0510
Diagram 4
3 Place Bike Carrier - Folding
Product Name:
Product Code: 59403
Diagram 5
Diagram 6
www.rolaproducts.com
59403N Rev B
Anti-Sway
Cradle
9-29-06