Stihl BC-KM Manual De Instrucciones página 12

B
a
8
Blades in position B
The blades can be set to this position for
shallow digging in previously cultivated,
packed soil, deep tilling loose soil,
weeding and working mulches into
loosened soil.
:
Changing position of blades
Starting from blade position A, remove
spring clip (4) and pin (5) from the hub.
Do not lose the washer (6).
BC-KM
C
a
b
5
4
6
7
Rotate blade (a) through 180° on rotor
shaft. Secure the blade on the rotor
shaft.
There is no need to change the position
of blade (b).
Blades in position C
This blade position ensures smoother
operation in lighter soil.
b Changing position of blades
Starting from blade position A, remove
spring clips (4) and pins (5) from the
hubs of blades (a) and (b). Do not lose
the washers (6). Pull both blades off the
rotor shaft and swap them over. Position
the blades so that the tips are facing
each other. Secure blade (a) on the rotor
shaft.
Loosen and remove the three fastening
screws (7) on blade (b). Rotate blade on
flange (8) about 30° counterclockwise
until the next hole lines up with a tapped
hole. Reconnect both parts with screws
(7) and mount on the cultivator's rotor
shaft.
English / USA
11