Information On Safeties; General Precautions; Mechanical Safeties; Electrical Safeties - IGF 4800 Manual De Uso Y Mantenimiento

I.G.F. Italstampi

1.1. GENERAL PRECAUTIONS

•
The slicer must be managed by skilled personnel, familiar with the instructions for use and
safety contained in this manual.
•
In the case of rotation of the personnel, vocational training is necessary.
•
Even if the machine comes with several safety systems, avoid setting the hands near the blade and
moving parts.
•
Before the cleaning and maintenance operations, check to make sure the machine is disconnected
from the mains.
•
Periodicaly check cable and electric elements conditions.
•
Never use the slicer for cutting freezed food, meat and fish with bones, or for non-food products.
•
Whenever the blade diameter is reduced of more than 10 mms., Apply to the assistance service for
replacement.
•
Never carry out repearing operations personnally, but apply always to skilled personnel.

1.2. MECHANICAL SAFETIES

The slicers we produce and which are described in this manual meet, as far as safeties are concerned, the
prescriptions on the risks of mechanical type issued by EEC. (as 89/392 - 91/368 - 93/44 - 93/68 - 89/336).
For the sanitary regulations they comply with the rule 89/109/EEC.

1.3. ELECTRICAL SAFETIES

The safeties against electrical risks comply with the rule 73/23/EEC and regulations CENELEC EN335/2 /64
All our slicers include a relay for restarting the machine whenever a fortuitous lack of current occurs.
Due to the perfect insulation of all the electric elements and the remarkable resistance of all the materials
used, our machines can be installed to work inside moist premises.
ATTENTION: DO NOT USE WATER TO CLEAN THE SLICER, ONLY A HUMID CLOTH
WARNING:
IN CONFORMITY WITH POINT 1.7.2. "INSTRUCTIONS ON FURTHER RISKS"
CONTAINED IN THE E.E.C. REGULATIONS 80/392 AND 91/368, THES PROTECTIONS AND SAFETIES
STRICTLY COMPLY WITH THESE REGULATIONS.
WE POINT OUT HOWEVER THAT THE ABOVE MENTIONED PROTECTIONS, EVEN IF THEY SENSIBLY
REDUCE BOTH THE POSSIBILITY AND EXTENT OF THE DAMAGE, DO NOT ELIMINATE FULLY THE
RISK OF CUTTING.
Technical features of the series of slicers "ART. 4800":
•
Possibility of intermittent work
•
Their use, cleaning and maintenance is quite safe
•
Thanks to their design and to the realization of all parts in stainless steel and anodized aluminium al-
loy without edges for easy cleaning operations, these slicers fully comply with the most strict sanitary
regulations.

1) INFORMATION ON SAFETIES

2) TECHNICAL FEATURES

PAGE: 16