Control Knob; Selecting Frequencies; Mode Selection - TTI TSC-100R Manual De Instrucciones

Control Knob

The Control knob is used to change the current display option.
In VFO mode, rotate the Control knob to change the displayed fre-
quency at the selected frequency steps. Rotate clockwise to increase
the frequency and counter clockwise to decrease the frequency.
In Menu mode, rotate the Control knob to change the selected setting.
In Channel memory mode, rotate the Control knob to step up or
down through the memories.

SELECTING FREQUENCIES

The receiver always selects the VFO mode when it is turned on. You can select frequen-
cies using the Control Knob.
Rotate the Control knob to step up or down in frequency from the starting point. The
frequency will change in the selected frequency step.
• To change frequency in 1 MHz step, press the Func key, then use the Con-
trol knob to change the frequency.
mode is activate).
Note : Then Func mode clears a few seconds after the last key press or control knob
change.
n Mode (AM,FM,WFM) Selection
By default, the receiver automatically selects the modulation Mode used for each band
(see the Frequency Band chart for the default modes for each band). It is not permitted
to manually change the mode.
10
is displayed while the Function
INSTRUCTION MANUAL TSC-100R/100RBT