Frequency Search; Selected Band Search - TTI TSC-100R Manual De Instrucciones

FREQUENCY SEARCH

n Selected Band Search
Use the Search function to locate active frequencies in one or more bands
1) Press the E/VFO key to select VFO Mode.
(Note: the receiver automatically selects the VFO
mode when it is turned on).
) Press the BAND key to select the required
Band. There are 4 factory preset Bands to
choose from (see Frequency Band Table).
3) Set the Squelch level using the Squelch
porq keys so that the noise just disappears.
4) Select a start frequency to Search from.
5) Press the SCAN SRCH key briefly. The 'SRCH' icon will be displayed and the
receiver will search the selected Band starting from the start frequency. Once the
end of the band is reached the Search continues at the beginning of the selected
Band.
6) To stop the Search, press the SCAN SRCH key again.
Note:
During the Search, press the BANK BAND key to move to the next Band.
1)
To change the Search direction rotate the Control knob clockwise or counter
)
clockwise.
The receiver will stay on an active channel according to the Busy Timer settings in
3)
the VFO Menu. If the Busy Timer is set to '5 Seconds', the receiver will continue
Searching after 5 seconds even if the channel is still busy. If the Busy Timer is set
to 'Busy', the receiver will remain on the busy frequency for as long as it stays
busy, then resume searching when the signal disappears.
1
3
1
2
INSTRUCTION MANUAL
4
5 6
TSC-100R/100RBT