Recalling Frequencies From The Memories; Channel Scan; Selected Bank Scan; Full Band Scan - TTI TSC-100R Manual De Instrucciones

1) Press the E/VFO key to select VFO Mode.
) Press Func MR. The receiver will enter the Memory Read mode.
3) To step through the memory banks press the BANK BAND key.
Memory banks are numbered 0 to 9.
4) Select the required channel using the control knob.
n Selected Bank Scan
Use the Scan function to locate active channels among the memorized channels in
one bank.
1) Press Func MR to select the Memory Read
mode.
) Press Bank/Band to select the preferred memory
bank.
3) Set the squelch level to a point where the receiver
is just quiet.
4) Press SCAN/SRCH. The receiver will begin scanni-
ng the selected Band.
Note:
If a signal is received, the receiver will remain on the active channel for the dura-
1)
tion of the 'Busy Timer' setting in the Menu setup. If the 'Busy timer' is set to Busy
the receiver will stay on the active channel for as long as the signal is present.
To change the bank while scanning, briefly press BANK/BAND key.
)
To change the scan direction while scanning, rotate the control knob clockwise
3)
or counter clockwise.
n Full Bank Scan
The Full Bank Scan function scans the entire memorized channel range for signals.
1) Press Func MR to select the Memory Read mode.
) Press Bank/Band to select the preferred memory
bank.
3) Set the squelch level to a point where the
receiver is just quiet.
4) Press and hold Scan/Srch for  seconds.
The receiver will begin scanning the entire full
Bands.
TSC-100R/100RBT

RECALLING FREQUENCIES FROM THE MEMORIES

INSTRUCTION MANUAL

CHANNEL SCAN

3
1
1
3
1
1
4
2
4
2
15