Yakima Q 71 Manual Del Usuario

96-01 Saturn
SW Wagon
TOOL REQUIRED: T15 Torx
NOTE: This two-part clip may not look
exactly like the clips pictured in your
OPEN REAR DOORS
AND REAR HATCH.
REMOVE
BODY COLORED TRIM:
Remove screw
above rear door.
WITH TOWERS ON VEHICLE,
INSTALL CLIPS:
Remember—this is a two-part clip and
may not look like the clips pictured in
your Q Tower instructions.
Attach unlined clip top
to towers.
REPLACE TRIMS:
• Slide tab into slot above door.
• Replace door screw.
• Replace hatch screw.
1031196M – 1/3
M1 M2 M3
32-1/4" 19" 30-3/4"
® wrench
Q Tower instructions.
REMOVE TRIM ABOVE REAR DOORS WITH A T15 TORX
Remove the 4 screws which hold door
trim with the T15 Torx
Remove screw at
end of trim from
inside hatch.
If not done–line
the underside of
the clip bottoms
with the black
vinyl stickers.
Refer to
Q-tower
instruction
to attach
clips.
Install bottom of trim
and rotate into position.
Secure with screws.
71
M4
VINYL LINERS:
34"
Line the
underside of
the clip bottoms
with the black
vinyl stickers.
® wrench.
Pick up trim at rear and lift upward.
Slide trim toward rear of car to release
the front end of the trim.
Position clip bottom at each tower.
Hook tower clips into clip bottoms.
CAUTION:
Do not pinch
rubber seals
during final
assembly—
check carefully!
A
Q71
®
WRENCH:
Pick out the front end of
the trim and gently pull
down to free the trim.
FOR TOWER
LOCATION:
Refer to
Steps 8 & 15
in Q Tower
instructions.
Use caution to avoid overtightening!
Roof damage can occur.
REFER TO THE Q-TOWER INSTRUCTION
FOR PROPER TIGHTENING, CAUTIONS,
AND REQUIRED SAFETY CHECKS.
LOAD WA R N I N G :
• Long loads will prevent rear hatch
from opening. (gear boxes,
canoes, skis, etc.)
• Bike mounts: For clearance, mount
facing backwards on vehicle.
165 lbs. / 75 kg
T15
REPEAT
PROCEDURE
to remove trim
from opposite
side.
Repeat
steps 8
through 10
for remaining
towers.
MAXIMUM LOAD:
Part # 1031196 Rev.M