Princess 242124 Manual De Instrucciones página 29

Part 2 - Rinsing
Place the lid (19) on the water reservoir (17).
Fill the water reservoir (17) with water up to
the maximum mark in the filling opening of
the lid (19).
Place the water reservoir (17) in the
appliance.
Place an empty pot (at least 1.8 l) under
the coffee dispenser (10).
Wait until the start/stop button (2) illuminates
green.
Press the start/stop button (2) to start the first
rinsing cycle. If the water level indicator (3)
flashes, the first rinsing cycle is completed.
Repeat the above steps to run the second
rinsing cycle. If the second rinsing cycle is
completed, the appliance switches off
automatically.
If the process is completed, set the locking
collar (8) to position 'B'.
Remove the lid (19) from the water reservoir
(17).
Remove the cover (20) from the filter holder
(21).
Remove the red steam valve (27) from the
filter holder (21).
Tightly screw the red steam valve (27) to
the steam outlet (30).
Place the anti-chlorine filter (18) in the filter
holder (21).
Place the cover (20) on the filter holder (21).
Make sure that the arrow on the cover (20)
points in the direction as shown (fig. B).
Place the lid (19) on the water reservoir (17).
Place the water reservoir (17) in the
appliance.
After descaling the appliance, clean the
coffee pad cassette (13), the milk frothing
unit and the coffee dispenser filter (28) in
soapy water using a soft brush.
Assembly
Warning! Before assembly, always switch off
the appliance and remove the mains plug from
the wall socket.
Mounting the anti-chlorine filter
and the water reservoir (fig. A & B)
Place the anti-chlorine filter (18) in the filter
holder (21).
Place the cover (20) on the filter holder (21).
Place the lid (19) on the water reservoir (17).
Place the water reservoir (17) in the
appliance.
Mounting the drip tray and the
cup tray (fig. N)
Place the drip tray (16) in the bottom of the
appliance.
(16) in the bottom of the appliance.
Mounting the dispenser cassette
and the coffee dispenser filter
(fig. K)
Mount the coffee dispenser filter (28) to the
dispenser cassette (9).
Mount the dispenser cassette (9) to the
appliance.
Mounting the coffee pad cassette
If you use coffee pads, refer to the section
"Making coffee with coffee pads".
If you use ground coffee, refer to the section
"Making coffee with ground coffee".
Mounting the milk frothing unit
(fig. J)
Warning! Push the tube adapter into the milk
froth dispenser adapter until it clicks into place.
If the tube adapter is not properly mounted to
the milk froth dispenser adapter, milk and hot
steam can escape from the milk froth dispenser.
Slide the flexible tube (24) over the tube
froth dispenser adapter (26) until it clicks
into place.
Mount the milk froth dispenser adapter (26)
to the red steam valve (27).
Mount the milk froth dispenser (12) to the
milk froth dispenser adapter (26).
29