Cleaning - Roscoe Medical NEB-DINO Manual Del Usuario

5. Taking deep breaths in, inhale the liquid medication vapor.
6. When liquid medication is depleted, turn the power switch to "OFF" (Fig. 10).
The compressor is designed for intermittent use only.
For optimal performance, operate the unit for 20 minutes on,
7. Unplug the power cord from the electrical outlet.
8. Detach the tubing and accessories from the compressor unit.
9. Clean nebulizer components before next treatment.
CLEANING THE NEBULIZER COMPONENTS AND ACCESSORIES:
1. Disconnect the tubing from the compressor and from the bottom of
the nebulizer cup.
2. If there is any moisture (condensation) in the tubing, let the compressor run
with the tubing only for 2 – 3 minutes. The warm air from the compressor
will dry out the tubing. Alternatively you can dry the tubing by removing it
from the compressor and hanging it up with the "ends down" to allow the
moisture or condensation to drain out and evaporate. Dampen a cloth with
warm water to wipe the exterior of the tubing.
3. Disassemble tubing end of the accessories.
4. Wash all parts with warm water and liquid dish soap. It is not necessary to
wash the tubing.
5. Rinse thoroughly with warm water and shake out water.
6. Air dry or hand dry nebulizer parts with a clean, lint free cloth. Reassemble
nebulizer when parts are dry and store. Make sure all components are
completely dry before storing.
CAUTION
then leave off for 40 minutes.

CLEANING

11
Figure 10