Roscoe Medical NEB-DINO Manual Del Usuario página 5

To reduce the risk of serious or fatal injury from electrocution, fire, burns and
to reduce the risk of damage or malfunction of the unit:
• Before use, check the serial number label on the bottom of the
compressor to ensure that the voltage and current indicated on the unit
correspond with the voltage and current available. DO NOT overload wall
outlets or use with power strips or extension cords.
• DO NOT use this product with a DC to AC converter, or with any AC
voltage and/or frequency other than specified
• Before use, check tubing and accessories for proper assembly. All parts
should be firmly in place. Use of improperly assembled tubing and
accessories could diminish or prevent adequate delivery or medication
and the effectiveness of the treatment.
• Tubing and accessories are for single patient use only. DO NOT share
your tubing and accessories with other patients.
• NEVER use tubing with a clogged nozzle. If the nozzle is clogged, the
aerosol mist will be reduced, altered, or stopped, which will diminish or
eliminate the effectiveness of the treatment. If clogging occurs, replace
with the same model.
DISCONTINUE OPERATION IMMEDIATELY IF ANY OF THE MOTOR
HOUSING PARTS BECOME DETACHED OR BROKEN, EXPOSING THE
MOTOR OR ANY OTHER ELECTRICAL COMPONENTS.
• DO NOT open or disassemble the compressor. Refer all servicing to a
Compass Health Brands authorized dealer.
• ALWAYS unplug immediately after each use and keep unplugged when
not in use. DO NOT run this product unattended.
• NEVER operate this product if it has a damaged cord or plug, is not
working properly or any abnormalities occur, has been dropped in any
way or into water, or has been exposed to any liquids inside the case.
Return to a Compass Health Brands authorized dealer for repair or
replacement.
• DO NOT use the nebulizer while operating a vehicle or while bathing.
• Keep all electrical cords away from heated surfaces. DO NOT operate or
store unit under direct sunlight, high temperature or humidity.
• The compressor motor has a thermal protector, which will shut off the
unit before it becomes overheated. When the thermal protector shuts the
unit off, please:
o Switch off the unit and unplug the unit from the electrical outlet.
o Wait 40 min. for motor to cool down before starting another treatment.
o Make sure the air openings are not obstructed and air filter is clean.
• DO NOT operate where oxygen is being administered in a closed
environment such as an oxygen tent.
WARNING
5