6.
7.
Enable/disable alarm
8.
9.
10. Press DOWN button again to disable the alarm. The
12 Snooze function
1.
2.
13 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press the CH button for about 3 seconds to initate reception
of measurements again.
16 / 88
Settings order: hours > minutes
Finally press the SET button to save the settings and
exit the setting mode.
In normal display mode, press SET button to switch to
alarm time display (AL).
Press DOWN button to enable the alarm. The
will be displayed.
symbol will disappear from the display.
When the alarm sounds, press SNZ button to activate
the snooze function. The alarm will sound again in 5
minutes.
Press any other button when the alarm sounds to inter-
rupt the alarm until the alarm time will be reached
again.
symbol