ASSEMBLY
5
CAUTION!
Before starting to assemble the equipment, it is necessary to pay attention to the following precautions:
•Check that the packaging is not damaged and that the parts and components of the equipment are not damaged.
•We recommend that the equipment be unpacked at the place where it will be assembled.
•The assembly site must be clean.
•Floor must be at and level, rm / hard to avoid equipment instability.
•The space around the equipment must be clear, as described in this Manual.
•It is recommended that the equipment be assembled away from moisture and out of sunlight to avoid damage to parts
of the equipment
•The icons instruct the user which tool to use, how many people to use to assemble the equipment, or to cross-tighten the
screws in a given step.
SCREW TIGHTENING TORQUE
SPECIFICATION TABLE
Diameter [mm]
M6
M8
M10
Fixed wrench Medium torque
Allen
Philips
Screw
driver
THE MOUNTING OF THE TOWER IS THE SAME FOR BOTH SIDES OF THE EQUIPMENT. TO
ASSEMBLE THE OTHER SIDE JUST FOLLOW AGAIN THE SAME STEPS DESCRIBED IN THE
Torque [N.m]
9-12
22-29
45-58
TOOLS
thread lock
1x
2x
For this assembly
For this assembly
it is recommended
it is recommended
that it be done by
that it be done by
one person or more
two people or more
LEVEL TO
25%
THE FLOOR
Leveling the
Only touch the
screw into the
equipment
part
to the oor
100%
give nal
tightening to the
screws
WARNING!
MANUAL.
11
ICONS
leveling
50%
S
Not giving
nal tightening to
the screws