Routine Inspections; Operation - Skymsen HS-98 Manual De Instrucciones

4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could cause
electrical chocks as well as electrical leak. Before use check conditions of all wires and
cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every
function and operational procedure have to be very clear to the operator. Contact your
nearest Dealer for further questions. Any manual command (switch, button or lever) shall
be given only after being sure it is the correct one.
4.2.8 Precautions
The electric cable has to be compatible with the power required by the machine. Cables
that touch the floor or are close to the machine need to be protected against short circuits
Oil reservoir has to be full up to the required level as indicated. Chqeck the level and add
oil when necessary.

4.3 Routine Inspections

4.3.1 Advice
When checking the tension of the belts or chains, DO NOT introduce your fingers between
the belts and the pulleys and nor between the chain and the gears.
4.3.2 Precautions
Check if motors and sliding or turning parts of the machine produce abnormal noises.
Check the tension of the belts and chains and replace the set when belt or chain show
signs of being worn out. When checking tensions of belts or chain, DO NOT introduce your
fingers between belts and pulleys, nor between the chains and gears. Check protections
and safety devices to make sure they are working properly

4.4 Operation

4.4.1 Advices
Do not work with long hair that may touch any part of the appliance, because they may
cause serious accidents. Tie them up and to the back, cover it with a scarf.
Only trained and qualified users can operate the appliance.
NEVER operate the appliance without any safety equipment.
14