Tabla de contenido
Publicidad
Setting
Gear II
Gear III
If the temperature is not set correctly, first set the hot air gun to a low temperature and gradually increase the temperature until the
best results are obtained.
7.1 Installation of correct accessories （optional）
Image
Make sure that the hot air gun is turned off and the nozzle has cooled down.
A fallen nozzle may ignite other items. Ensure that the nozzle is fixed securely to the machine.
Touching a hot nozzle may cause severe burns. Install or replace the nozzle after the machine has completely cooled down or using the
97924
Dry tonal specimens, joint sealants, mucilage glue, construction joints and plaster models.
Catalyze such adhesives as contact adhesives on bonding surfaces, activate adhesives to
accelerate the gluing process, melt away bonding points and remove or attach plastic film
Melt frozen steps, door locks, trunk lids, doors and water pipes. Remove frost deposits from
Weld tin, special silver solder, SMD building elements and cable terminals, and desolder tin
Livestock sheds may be quickly sterilized with hot air at 600 ℃ . In addition, it may be used
to effectively cope with xylophagous insects （note: this machine has a risk of fire. Wooden
Description
Economic shovel-shaped nozzle
Economic reflector nozzle
Economic round nozzle
Economic wide-slot nozzle
Economic scraper
中文
Application
Dry wet wood.
Remove stickers.
along plate edges.
Wax and dewax.
Shrink packages and insulated PVC pipe.
refrigerators and freezers.
Weld plastic.
Bend plastic pipes and sheets.
joints.
Loosen rusty or fixed nuts and tighten bolts.
Remove old and thick grease, paint scale and plaster.
surfaces must not be overheated）.
EN
DE
RU
KO
Purpose
Protect glass when peeling stickers from
window frames.
Welding soft fiber tubes.
Welding and shrinking the film （low heat）
Drying and melting （high heat）.
Scraping off paint to clean surfaces.
PT
JA
ES
11
Publicidad
Tabla de contenido
