Getting Started; Installing The Batteries - STACK-ON PC-1665 Instrucciones

GETTING STARTED

When you rst receive your case you will need to
open the cover with the key in order to install the
ba eries. Ba eries are included and are located
inside the case.
NOTE: is key has also been provided if you lose
or forget your security code or the ba eries run
low. If you lose your key, you may purchase a
replacement key by referencing the serial number
located on the back of the case. See section
regarding replacement keys for further
information.
To open the case, insert key into lock and turn
counterclockwise until the cover automatically
opens. NOTE: You must turn the key back to the
locked position before you are able to close and
lock the cover.

INSTALLING THE BATTERIES

NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
Pull the foam upward and away from the ba ery
compartment. Remove the ba ery compartment by
pushing the tab and pulling the compartment out as
shown. Install (4) AAA alkaline ba eries as shown.
Reinstall the compartment by hooking the back end
in place and snapping shut. CAUTION: Be careful
not to pinch any wires while reinstalling the ba ery
compartment.
NOTE: If the ba eries are low the combination
bu ons will ash red when pushed. Replace the 4
AAA ba eries with new alkaline ba eries as
described below.
OPEN
CLOSE
2
12
40656-1512