SECURING THE CASE WITH THE CABLE
For optimal performance, the case should be
installed in an isolated, dry and secure area
THE CASE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
NOTE:
is case is designed to be secured with a
cable that is a ached to a xed object. Failure to
to do so will compromise the safety and security
of the case.
To secure the case to a xed object, loop the cable
around the object and place the cable's small end
into the notch on the side of the case. Tip the cable
end down while inserting in the notch. Locking the
case will secure the cable end inside the case.
TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound turned on.
You can turn o the "Beep" sound of the keypad by
pressing all the bu ons at the same time and
holding for 3 seconds until the green light ashes.
To turn the "Beep" sound on, press the le and
middle bu on at the same time and hold for 3
seconds until the green light ashes.
NOTE ON LOCKING THE CASE:
needs to be in an upright position, as shown in
gure 1, for optimum performance. Failure to
store the case in the correct upright position will
compromise the safety and security of the case.
NOTE:
is unit is not an approved California
Department of of Justice rearm safety device.
IMPORTANT
Keep keys and your combination number in a
secure place, away from children. Keep this record
of your serial number and combination in a secure
place separate from your safe. To order a
replacement key set, follow the instructions on the
a ached form.
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
e case
Figure 1
4
12
40656-1512