Service Timer; Change Pin; Service Functions; Restore Defaults - Crowcon Gas-Tec Manual Del Usuario

Managing the Gas-Tec

7.3 Service Timer

Press ENTER to get into the Service Timer menu . Use this to change the Service Date, Service Lock,
and Error Override options .
Press ENTER again to use the first option shown to set the time to elapse before the unit is due to be sent
for service . When this has been chosen the screen will automatically jump back to the Service Timer menu .
Press BACK to go back to the ADMIN menu, or press the down key to select other options as required .
Set the Service Lock to prevent the unit being used after the Service Date entered in the first step .
Choose the last option to allow an Error Override, this allows the Gas-Tec to restart attempting to clear
any known failure modes . If the Gas-Tec still reports an error after running this option, please contact your
local authorised Crowcon service centre .

7.4 Change PIN

Use the soft key by the UP and DOWN arrows to select option to change the PIN if this is required (see VII .2) .

7.5 Service functions

Instructions for updating firmware and calibrating the Gas-Tec can be found in the Service Manual .
Admin Menu Structure
Enter pin (1234)
Service Timer Change pin
Set
Service
Timer
Calibration may only be performed by an approved service engineer . A pin number is required for access
to this function – it will only be issued to appropriate personnel . This function is password protected .

7.6 Restore Defaults

THINK CAREFULLY before using the Restore Defaults instruction here, as vital data may be lost . This
function is password protected .

7.7 Switch off the Gas-Tec

If the administrator menu is entered, the Gas-Tec will remain in administrator mode until turned off .
36
Set Error
Service override
Lock
Calibration GPS
Restore
Defaults
Gas-Tec