Parameterizing The Machine - Furius FIX 161 MINI Manual De Instrucciones

Instructions for setting and parameterizing the machine
9.
Turn the knob to adjust the current.
The adjusted value will be shown on the display
Prepara�on for applying manual metal arc welding (MMA/SMAW)
Connect the work clamp (ground) to the piece to be welded. Make sure there is a good electrical
connec�on in the equipment. Remove any rust, paint, or any contamina�on using a wire brush or
polisher (grinder, angle grinder) before connec�ng.
If you use a metal table for welding, you should regularly check the connec�on of the work clamp
(ground) for signs of contamina�on or corrosion. A good ground connec�on is essen�al for good
results in the welding applica�on.
Electrode igni�on
Insert the electrode into the jaw of the electrode holder by pressing the lever on the electrode
holder. Make sure you have proper eye protec�on (face shield) before you start welding.
Note: UV radia�on damage is par�cularly high during arc start.
To start the arc, scratch the electrode over the spot to be welded in a similar way to how a match
is lit. The 80V no-load voltage ignites the electrode quickly, and direct current (DC) allows the
electrode to melt evenly. If you are a beginner do not expect good results on the first a�empt, take
training courses and courses in welding.
16