Skymsen SI-315HD Manual De Instrucciones página 13

PICTURE 08
01
- Blade Scraper
Slide the Blade Scraper sideway until it gets out
- Wheel Scraper
Remove the Lower Wheel, then pull the Scraper towards the saw front side until it gets
out.
Blade Tension Regulator
Stand behind the saw and remove the Upper Back Cover #.01 (Pic.10). Turn the Blade
Tension Regulator Handle # 02 (Pic.11) counter clockwise until the Blade Tension Regulator
# 01 (Pic.11) gets free to be removed.
Also remove the Blade Tension Regulator Handle # 02 (Pic.11).
PICTURE 10
- Wash all the parts with water and neutral ph detergent.
Do not spray water directly on the Lower Bearing, the Controll Board and the
Motor Housing # 21 (Pic. 01), principally at the ventilation points.
Use clean clothes or soft brushes to remove residues.
Washing and sanitization shall be regularly performed and then all parts shall be carefully dried.
To assemble the several parts removed proceed inversely as above instructed, make sure
all parts to be properly assembled.
01
IMPORTANT
PICTURE 09
PICTURE 11
03
02
13