Introduction; Safety - Skymsen SI-315HD Manual De Instrucciones

1. INTRODUCTION

1.1 Safety

If and when the Band Saw Model SI-315HD is not correctly used it is a potentially
DANGEROUS machine. Cleaning, maintenance and any other service in the machine shall
be carried out by duly trained people and with the plug off its socket. The instructions
below must be always followed to avoid ACCIDENTS:
1.1.1 Take the electric plug off its socket, before to withdraw any moving part, before
cleaning, maintenance or any other kind of service.
1.1.2 Never use any kind of tools not belonging to the Saw to help during operation.
1.1.3 Never touch the blade # 08 (Pic.01) when the saw is in operation
1.1.4 Never wear loose clothes with wide sleeves mainly around the wrists during
operation.
1.1.5 Never adjust the Thickness Guide # 13 (Pic.01) with the saw blade in movement.
1.1.6 Keep hands away from moving parts.
1.1.7 Never switch on the Saw with wet clothes or wet feet.
1.1.8 Ground machine properly during installation.
1.1.9 The saw has a Thermal Protector for the motor protection. Motor and the operator
are protected in case of over heating.
Therefore if the equipment suddenly STOPS, wait some minutes, and after reset the
Thermal Protector pressing the Button # 01 (Pic. 02)
4