Dyna-Glo DGP700SSB Manual Del Usuario E Instrucciones De Funcionamiento página 16

Step 12: Assemble the left side burner assembly (14).
A. Partially insert 3 screws (F) to the grill
body (13) as shown in Fig. A (leave
approximately 4-6mm between the
screw head and the surface of the grill
body (13). Align the keyholes in the left
side burner assembly (14) with the 3
screws just installed in the grill body
(13). Slide the left side burner assembly
(14) onto the screws. Secure the left
side burner assembly (14) to the grill
body (13) by inserting 2 additional screws (F) in remaining holes.
Tighten all five screws (F).
B. Align the brass orifice of the side burner feeder hose with the
center of the side burner tube (located on the underside the left
side burner assembly (14)). Make sure the orifice is inserted into
the center of the side burner tube. See Fig. b and Fig. c. Using
2 screws (D) sure the orifice support bracket to the side burner
support bracket.
C. Connect the ignition wiring to the electrode as illustrated.
D. Install the side burner grate (15).
Hardware Used
F M6x16 Screw
D M4x10 Screw
Dual Fuel Grill
ASSEMBLY INSTRUCTIONS
Fig. b
D
Qty: 5 pcs
Qty: 2 pcs
12
13
Fig. c
14
Fig. A
F
15
14