How To Use; Controls - Vornado Flippi V Guia Del Propietario

How To Use

Flippi™ was engineered to provide just the right amount of air, either direct-
ed at you to create a nice breeze, or away from you to create swirling currents
of air, rejuvenating your personal space.
Direct Airflow
The power head can be adjusted 180 degrees to
direct airflow where you need it. Or for an unobtru-
sive look when not in use, the power head can be
A
positioned down into the "nested" position. Do
not operate the fan when in the nested position, as
no air will be circulated. Position Flippi away from
objects that may block airflow.
Power (A) The unit functions ON and OFF by pressing the POWER button.
Lights on the unit's control panel indicate the power is ON.
Fan Speed (B) The fan speed can be adjusted by pressing the POWER
button. Press the button to switch between the unit's 3 speed settings.
Lights on the unit's control panel indicate the selected speed setting.
B
Oscillation (C) Oscillation can be selected by pressing the Oscillation But-
ton, press again to switch OFF. Note: Oscillation only works when the main
power is ON.
8 English
C
Remote Control Requires a line-of-sight path to the blue lens on the front
of the base to allow for the signal to be received by the unit. To turn the unit
ON or OFF, press the Power Button (D). To switch between the 3 fan speeds,
press the Fan Speed Button (E). To turn oscillation ON or OFF, press the
Oscillation Button (F). Note: Flippi will resume operation with the previous
settings next time it is powered ON with the Remote.
Remote Control Battery The remote control comes with a 3 Volt lithium
coin cell battery (CR2032). To install, remove the battery cover on the bottom
of the remote control. Remove any plastic protection from the battery and
place it in the remote with the + side facing out. Then reposition the cover
onto the bottom of the remote. If your remote does not work, please try
replacing with a new 3 Volt CR2032 battery.

Controls

D
E
A
B
F
English 9