MBM PEE7750I Manual De Uso E Instalación página 29

Upon arrival, check the integrity
of the appliance and its compo-
nents (e.g. power cord), prior to
use. In the presence of faults do not
start the appliance and contact the ne-
arest service centre.
Read the instructions before
acting.
be performed. As far as personal pro-
tective equipment is concerned, the
European Community has issued Di-
rectives which the operators must com-
ply with. Noise ≤ 70 dB.
It is forbidden the installation of
stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the connections
check the technical data shown
on the rating plate of the applian-
ce and the technical data in this manual.
It is strictly forbidden to tamper with
or remove the plates and pictograms
applied to the equipment.
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the appli-
ance whenever you need to work in
safe conditions.
Connect the appliance if pre-
sent, in the sequence of the wa-
ter, then to the gas network. Ensure
there are no leaks then proceed with
the connections to the mains.
The appliance is not designed to
work in an explosive atmosphe-
re and as such its installation
and use is categorically prohibi-
ted in such environments.
Position the entire structure, re-
specting the installation dimen-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suitable
for the operations to
- 5 -
sions and characteristics indicated in
the specific chapters of this manual.
The appliance is not intended for
recessed installation. / The ap-
pliance must be used in a well
ventilated area. / The appliance must
have free drainage (not hindered or im-
peded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is connect-
ed to the power and drain
sources, it must remain static
(fixed) in the place of use and mainte-
nance. Incorrect
cause danger.
Use where appropriate flexible
cable for connection to the mains
electricity supply with characteri-
stics not inferior to model H07RN-F.
The supply voltage supported by the
cable with the appliance working must
not differ from the nominal voltage va-
lue ± 15% shown at the bottom of the
technical data table.
The appliance must be included
in an "Equipotential" ground dis-
charge system.
Drainage of the appliance must
be conveyed into the grey water
discharge network in an open
"glass" unsiphoned formation.
The appliance must only be
used for the purposes indicat-
ed. Any other use must be con-
sidered "IMPROPER" and therefore
the manufacturer declines all liability
for any consequent damage to per-
sons or property.
connection may
2.
EN