Menu Language - LaserLiner MoistureMaster Compact Plus Manual Del Usuario

9
MAX value
The MAX value is the maximum measured value within a single measurement.
Press both arrow buttons at the same time to reset the MAX value to zero. Do
make sure that the Sensor pads on the rear of the device do not come into
contact with the material being measured or with your hands when you press
these buttons.
8.2%
10

Menu language

To access the menu, simultaneously press and hold the two arrow buttons
in the "measured value" display. Now you can use the arrow buttons to set
the required language; confirm your selection with "MODE".
2 sec
11
Setting the wet/dry threshold values in index mode and
Index Zoom mode
The wet/dry LED indicator is programmed in line with the relevant material
characteristics so the LEDs also provide information about whether the material
should be classified as dry, moist or wet. However the values in index mode
and Index Zoom mode, which is independent of the material type, are output
on a neutral scale whose value increases as the moisture level rises.
The LED indicator can be specifically programmed
for index mode and Index Zoom mode by
defining the end values for "dry" and "wet".
The difference between the value set for
"dry" and that set for "wet" is converted
and displayed by the 12 LEDs.
MoistureMaster Compact Plus
Language
ENGLISH
0.0%
Select language
DRY WET
limit limit
21
EN