Kohler K-3341 Guia De Instalacion página 7

Install the Sink (cont.)
Apply a continuous bead of quality sealant to the top surface of
the sink rim where it will contact the countertop. Follow the
instructions listed on the sealant label.
NOTE: The screws provided should be used on countertops with a
minimum 1" (2.5 cm) thickness. For thinner countertops, use the
appropriate anchors and fasteners (not provided).
For wood, wood composite, and marble countertops, install the
sink to the countertop with the clamps and screws provided. For
other countertop materials, refer to the countertop manufacturer's
instructions for recommended fasteners.
Position the sink squarely under the cut-out before tightening the
clamps. Draw the sink rim up against the countertop until it is
snug. Do not overtighten.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Allow the sealant to cure for at least 30 minutes before
proceeding.
Connect and tighten the trap to the strainer, and complete the
water supply connections to the faucet according to the
instructions packed with the faucet.
Run water into the sink and check for leaks.
Clean up with a non-abrasive cleaner.
Kohler Co. 7 1019945-2-B