Controlling The Reducer Gearbox Oil Level - Nogueira VMN 4.0 Manual De Instrucciones

Controlling the Reducer Gearbox Oil Level

Changing the Oil in the version with the milling machine
The control of the oil level in the reducer gearbox must be always done after operating, as the oil flows
better in this condition.
The oil level can be verified by the visor (A fig.1A) through the inspection hole on the left side of the
reducer gearbox. (See the "Summarized maintenance table" to check the appropriate oil change
periods, after 10 hours of operation and then every 50 hours thereafter).
Remove the filling plug to fill the oil (B fig.2A) by the upper access hole on the reducer gearbox and fill
until the MAX level as displayed on the visor (A fig.1A).
For changing the oil, remove the drain plug (C fig.3A) from the reducer gearbox and remove the filling
plug (B fig.2A) in order to make the oil drain faster (For the oil change periods, see the "Summarized
maintenance table").
(The old oil must be discarded as stated in the local applicable environmental regulations).
Replace the drainage plug (C fig.3A), fill the oil until the MAX level as displayed on the visor (A fig.1A)
(see the "Lubricant quantity table"). Close the filling plug (B fig.2).
32
Instruction Manual