Protection; Overheating Protection; Charging Time; Declaration Of Compliance - GYS TECH 750 Manual Del Usuario

PROTECTIONS
In case of problem, the charger automatically switches on protection. To avoid damaging the
battery and the charger, the system will remain in that position until action of the user.
Problem
Flashing red
charging
indicator
Indicator
switched on.

OVERHEATING PROTECTION

Gystech 750 charger is protected by a thermal sensor. During the charging process, if the charger
becomes too hot or due to extreme ambient temperature, the power output is automatically
reduced to protect itself from damage. The charger continues to work trickle charge. Charger
increases power automatically when the ambient temperature drops.

CHARGING TIME

Battery
size (Ah)
2
8
20

DECLARATION OF COMPLIANCE

The company GYS certifies that the product described on this manual is manufactured in
compliance with the requirements of the following European directives :
- Low Voltage Directive : 2006/95/EC - 12/12/2006 (amended by 93/68/EEC)
- EMC Directive : 2004/108/EC, 15/12/2004 (amended by 92/31/EEC, 93/68/EEC, 91/263/EEC,
93/97/EEC),
It therefore complies with the following harmonized standards :
- EN60335-1 - EN60335-2-29 – EN55014-1 - EN55014-2 – EN61000-3-2
– EN61000-3-3 – EN62233.
Causes
Short circuit
Circuit open
Battery voltage <3,75V +/-
0,25V
(for 6V battery).
<7,5V +/- 0,25V
(for 12V battery).
Polarity reversal
Charging time from 20% to 80% Charge(hours)
Charge 1H30 + maintenance
Charge 7H+ maintenance
Charge 16H00 + maintenance
Solutions
- Check that there is no voltage
loss in the vehicle circuit.
- Check that the clamps are well
connected.
- After corrections, if the
indicator is still on, the
sulfated or damaged battery
may be replaced.
Check that the clamps are well
connected
10