Important; Symbols; Pre-Installation Information; Safety Information - Energie MONOBLOC 100esm Manual Tecnico

MONOBLOC 100L

1. IMPORTANT

1.1. Symbols

Every process that the supplier believes to be conducive to harmful danger and/or
material damage, will be signalled with a danger sign.
For a better characterization of the danger, the symbol will be followed by one of
these words:
• DANGER: when there is the possibility of harm to the operator and/or people in
the vicinity of the equipment.
• WARNING: when there is the possibility of material damage to the equipment
and/or attached materials.
All the information that the supplier believes to be an asset for better performance
and preservation of the equipment, will be signalled together with the information
sign.

1.2 . Pre-installation Information

The electrical installation of the equipment must comply with the national regulations for electrical
installations in effect.
AQUAPURA MONOBLOC will only operate after receiving its load of coolant.
The maximum water pressure into the hydraulic circuit inlet is 0.3 Mpa and the minimum pressure is
0.1 MPa. The power supply is 230 V, 50 Hz, and the power supply cable is plugged into a socket with
earth wiring.
If the power supply cable is damaged, it must be replaced by the manufacturer, by its customer ser-
vice, or by staff with similar training in order to avoid any danger.
AQUAPURA MONOBLOC will only operate if the storage water heater is filled with water.
Heating of fluid other than drinking water is not allowed.

1.3 . Safety information

This device can be used by 8 year old children and older, or people with physical,
sensorial or mental handicaps, or lacking experience / knowledge, if they received
training regarding the running of the device in a safe way and are aware of the dan-
gers involved.
Children must not play with the appliance.
DANGER
Cleaning and maintenance must not be carried out by children unless they are under
supervision.
When installing:
• The installation of a thermodynamic equipment for heating sanitary water must be carried out by
staff with suitable training and qualified for this purpose;
• The device should not be installed in places that present a risk of impact, shock or explosion;
• Keep the equipment packed until you reach the place and moment of installation;
34
WARNING / DANGER
Technical Manual