Interface With The User - Energie MONOBLOC 100esm Manual Tecnico

MONOBLOC 100L

5.4. Interface with the user

1 - 1 - ON/OFF equipment
Press the key to turn on or turn off the equipment.
Notice: After turning on the equipment you will have 5 min until the equipment begins to
function (compressor's start-up temporization)
2 - Block/ unblock keyboard
To unblock the keyboard press the key
occurs 30s after any inactivity on the keyboard. When the keyboard blocks this message is
presented on the display for 1s "Loc".
3 - Information on the display while functioning
While functioning the information presented on the display corresponds to the water's tem-
perature.
4 - Way of functioning ongoing
To verify the way of functioning ongoing click on the key
on the display the adopted way.
To change the way of functioning press the key
select the way of functioning, after being selected press the key to
activate the new way of functioning.
5 - Change functioning set point
To change the functioning set point press the key
the display SP1, to change to SP2 or SP3 use the pointers
After selecting the parameter you want to change press the key
rameter and with the pointers
To confirm press again the key
Parameter
Functioning set point of the compressor on ECO mode.
SP1 Functioning set point of the compressor and of the resistance on ObSt mode if
the ObSt mode is active during the ECO function.
Functioning set point of the compressor and of the resistance on AUTO mode.
SP2 Functioning set point of the compressor and of the resistance on mode if the
ObSt mode is active during the AUTO function.
Set point to activate "ObSt" mode, that is to say, the function will only start when
SP3
the water temperature in the thermal accumulator under SP3.
50
for 4s. The keyboard blocking is automatic and
(increase) or
.
Description
Technical Manual
, automatically will appear
for 2s, with the pointer
and it will immediately appear on
or .
to enter in the pa-
(decrease) the parameter value.
or
confirm/