Festo CPX Serie Instrucciones Para El Usuario página 22

Fitting the I/O module:
1. Only in cases where the electronic module has been
removed: Press the electronic module carefully into
the manifold sub−base.
2. Check the seal and sealing surfaces and refit the sub−
base.
3. Place the screws so that the self−cutting threads are
used. Tighten the screws by hand in diagonally oppo
site sequence. Tightening torque 0.9...1.1 Nm.
3.3 Installation
Sensors and actuators can be connected to the I/O mod
ules depending on the sub−base used.
Please note
When connecting the sensors and actuators, note the
instructions in the manual CPX I/O modules and pneu
matic interfaces."
22 Festo CPX−EA 0503a English