Lenze g7 0 Serie Instrucciones De Montaje página 17

Motor mounting B14
1.
• Check connecting dimensions of motor flange and gearbox
flange.
• If mounted, loosen the adapter plate from the gearbox flange.
• If available, remove the featherkey from the motor.
3.
• Remove the cover screw.
• Connect adapter plate and motor using four screws.
• The adapter plate must lie flat on the motor flange.
• Tighten the screws crosswise.
• Secure the screws using screw locking adhesive.
5.
SW
• The motor flange must lie flat on the gearbox flange.
• Tighten the clamping hub with T
• Screw on the cover screw and tighten it by hand.
+0 0 .
0
T
A,K
.
A,K
2.
• Thoroughly clean all surfaces. They must be free of grease.
4.
• Loosen the screw in the clamping hub.
• Adjust the clamping hub.
• If the diameter of the motor shaft is smaller than the one of
the gearbox's hollow shaft, the attached reducing bush must
be inserted into the gearbox's hollow shaft.
• Insert the motor shaft into the gearbox's hollow shaft.
6.
SW
• Connect the motor and gearbox using four screws.
• Tighten the screws crosswise.
• Secure the screws using screw locking adhesive.
Mechanical installation
Mounting
17