Filling The Detergent; Using Combined Detergents; Rinse-Aid Usege; Filling The Rinse-Aid And Setting - EAS ELECTRIC EMD14AZI Manual De Instrucciones

Using little detergent can result in poor
cleaning and you can see whitish streaksin
hard water.
See the detergent manufacturer's
instructions for a further information.

4.9. Filling the detergent

Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.

4.10. Using combined detergents

These products should be used according
to the manufacturer's instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If rinse aid dosage
setting set too low, whitish stains remains
on dishes and dishes do not dry and
washed clean.
If rinse aid dosage setting set too height,
you can see bluish layers
on glass and dishes.

4.12. Filling the rinse-aid and setting

To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX level
and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe
up any spills.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
• Push the programme button and hold it
down.
• Turn on the machine.
• Hold down the programme button until
"rA" disappears from the display. Rinse
aid setting follows water hardness
DETERGENT
setting.
• The machine will display the current
setting.
• Change the level by pushing the
programme button.
• Switch off the machine to save the
setting.
The factory setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Level
1
2
3
4
5
EN - 11
Brightener Dose
Rinse-aid not r1 is shown on the
dispensed
1 dose is r2 is shown on the
dispensed
2 doses are r3 is shown on the
dispensed
3 doses are r4 is shown on the
dispensed
4 doses are r5 is shown on the
dispensed
Indicator
display.
display.
display.
display.
display.
V.1