Honda GCV530 Manual Del Propietário página 8

37Z0A6000.fm 8 ページ ２０２０年４月２７日 月曜日 午後１時３４分
Oil Change
Drain the used oil when the engine is warm. Warm oil drains quickly and
completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, drain bolt and sealing washer.
2. Allow the used oil to drain completely, then reinstall the drain bolt
and new sealing washer, and tighten the drain bolt securely.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
Please dispose of used motor oil in a manner that is compatible with
the environment. We suggest you take used oil in a sealed container
to your local recycling center or service station for reclamation. Do
not throw it in the trash, pour it on the ground, or pour it down a
drain.
3. With the engine in a level position, fill to the upper limit mark on the
dipstick with the recommended oil (see page 7).
Engine oil capacity: 1.1 L (1.16 US qt, 0.97 lmp qt)
Running the engine with a low oil level can cause engine damage. This
type of damage is not covered by the Distributor's Limited Warranty.
SEALING
WASHER
(Replace)
OIL DRAIN BOLT OIL FILLER CAP/DIPSTICK
4. Install the oil filler cap/dipstick securely.
Wash your hands with soap and water after handling used oil.
8
OIL FILTER (applicable types)
Oil Filter Change
1. Drain the engine oil, and retighten the drain bolt securely.
2. Remove the oil filter with an oil filter wrench, and drain the remaining
oil into a suitable container. Dispose the used oil and filter in a
manner compatible with the environment.
Use an oil filter wrench, rather than a strap wrench, to avoid striking and
damaging the oil filter.
OIL FILTER WRENCH
UPPER LIMIT
LOWER LIMIT
3. Clean the filter mounting base, and coat the seal of the new oil filter
with clean engine oil.
Use only a Honda Genuine oil filter or a filter of equivalent quality speci-
fied for your model. Using the wrong filter, or a non-Honda filter which is
not of equivalent quality, may cause engine damage.
4. Screw on the new oil filter by hand until the seal contacts the filter
mounting base, then use an oil filter wrench to tighten the filter an
additional 7/8 turn.
Oil filter tightening torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
5. Refill the crankcase with the specified amount of the recommended
oil (see page 7). Reinstall the oil filler cap/ dipstick.
6. Start the engine, and check for leaks.
7. Stop the engine, and check the oil level as described on page 7. If
necessary, add oil to bring the oil level to the upper limit mark on the
dipstick.
ENGLISH
OIL FILTER FILTER MOUNTING BASE
SEAL