Air Index; Specifications; Tuneup Specifications; Information - Honda GCV530 Manual Del Propietário

37Z0A6000.fm 16 ページ ２０２０年４月２７日 月曜日 午後１時３４分
Replacement Parts
The emissions control systems on your new Honda engine were
designed, built, and certified to conform with U.S. EPA, California, and
Canadian emissions regulations. We recommend the use of Honda
Genuine parts whenever you have maintenance done. These original-
design replacement parts are manufactured to the same standards as the
original parts, so you can be confident of their performance. Honda
cannot deny coverage under the emission warranty solely for the use of
non-Honda replacement parts or service performed at a location other
than an authorized Honda dealership; you may use comparable U.S. EPA
certified parts, and have service performed at non-Honda locations.
However, the use of replacement parts that are not of the original design
and quality may impair the effectiveness of your emissions control
system.
A manufacturer of an aftermarket part assumes the responsibility that
the part will not adversely affect emissions performance. The
manufacturer or rebuilder of the part must certify that use of the part will
not result in a failure of the engine to comply with emissions regulations.
Maintenance
As the power equipment engine owner, you are responsible for
completing all required maintenance listed in your owner's manual.
Honda recommends that you retain all receipts covering maintenance on
your power equipment engine, but Honda cannot deny warranty
coverage solely for the lack of receipts or for your failure to ensure that all
scheduled maintenance has been completed.
Follow the MAINTENANCE SCHEDULE on page 6.
Remember that this schedule is based on the assumption that your
engine will be used for its designed purpose. Sustained high-load or
high-temperature operation, or use in dusty conditions, will require more
frequent service.

Air Index

(Models certified for sale in California)
An Air Index Information label is applied to engines certified to an
emission durability time period in accordance with the requirements of
the California Air Resources Board.
The bar graph is intended to provide you, our customer, the ability to
compare the emissions performance of available engines. The lower the
Air Index, the less pollution.
The durability description is intended to provide you with information
relating to the engine's emission durability period.
The descriptive term indicates the useful life period for the engine's
emission control system. See your Emission Control System Warranty for
additional information.
Descriptive Term Applicable to Emissions Durability Period
Moderate 50 hours (0–80 cc, inclusive)
125 hours (greater than 80 cc)
Intermediate 125 hours (0–80 cc, inclusive)
250 hours (greater than 80 cc)
Extended 300 hours (0–80 cc, inclusive)
500 hours (greater than 80 cc)
1,000 hours (225 cc and greater)
16

Specifications

Length×Width×Height
Dry mass [weight]
Engine type
Displacement
[Bore×Stroke]
Net power
(in accordance with SAE J1349*)
Max. Net torque
(in accordance with SAE J1349*)
Engine oil capacity
Cooling system
Ignition system
PTO shaft rotation
* The power rating of the engine indicated in this document is the net
power output tested on a production engine for the engine model
and measured in accordance with SAE J1349 at 3,600 min
-1
Power) and at 2,500 min (rpm) (Max. Net Torque). Mass production
engines may vary from this value.
Actual power output for the engine installed in the final machine will
vary depending on numerous factors, including the operating speed
of the engine in application, environmental conditions, maintenance,
and other variables.

Tuneup Specifications

ITEM SPECIFICATION
Spark plug gap 0.7–0.8 mm
(0.028–0.031 in)
Idle speed
+200
1,400
-150
Valve clearance IN: 0.10±0.04 mm
(cold) EX: 0.15±0.04 mm
Other
specifications
Quick Reference Information
Fuel Unleaded gasoline (Refer to page 7)
Research octane rating 91 or higher
Pump octane rating 86 or higher
Engine oil SAE 10W-30, API SJ or later, for general use.
Refer to page 7.
Spark plug BPR5ES (NGK)
W16EPR-U (DENSO)
Maintenance Before each use:
• Check engine oil level. Refer to page 7.
• Check air filter. Refer to page 9.
First 20 hours:
Change engine oil. Refer to page 8.
Subsequent:
Refer to the maintenance schedule on page 6.
ENGLISH
458×427×343 mm
(18.0×16.8×17.1 in)
31.2 kg (68.8 lbs)
4-stroke, overhead camshaft, 2 cylinders
(90° V-Twin)
3
530 cm (32.3 cu-in)
[77.0×57.0 mm (3.03×2.24 in)]
11.3 kW (15.4 PS, 15.2 bhp)
-1
at 3,600 min (rpm)
33.1 N·m (3.38 kgf·m, 24.4 lbf·ft)
-1
at 2,500 min (rpm)
1.1 L (1.16 US qt, 0.97 lmp qt)
Forced air
Transistor magneto
Counterclockwise
-1
(rpm) (Net
MAINTENANCE
Refer to page 10.
-1 See your authorized
min (rpm)
Honda dealer
No other adjustments needed.