Servicing The Sensor With The Tire Installed; Tire Removal; Breaking The Bead - Magneti Marelli TPMS CONNECT EVO Guía Rápida

You may retrieve the correct tightening torques for sensor
installation and view them on tester display using the function
described in paragraph 12.3 "Tightening torques".
Manufacturer (OEM) part numbers for sensors may be viewed on
tester display using the function described in paragraph 12. " Part
Number".
Check sensor for proper operation before refitting the wheel to avoid
removing the wheel again in the event the sensor needs to be
replaced.

17.3. Servicing the sensor with the tire installed.

The instructions outlined above require tire removal. Some tire changers equipped
with double rollers enable sensor inspection and replacement with no need to remove
the tire. If you have this type of equipment, please refer to the manufacturer's
instructions.

18. Tire removal

TPMS-equipped wheels with internal sensors must be handled with great care during
tire removal and installation procedures. A suitable tire changer and proper bead
lubrication will greatly facilitate these operations.
Remove valve cap and insert and wait until tire deflates before breaking the bead.
Test sensor for proper operation before proceeding.

18.1. Breaking the bead

23