Commands Description - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
6.

COMMANDS DESCRIPTION

Front Panel
assembly
1A
1B
10
9
9A
8
7
6
(*) Use it only for Software download. Remove the front panel (4 screws) to find the download switch and the RS232 connector. For any other informations, please
contact our nearest service point.
(**) On pin 5 and 6 of the 7 pin socket there is the ARC ON signal. The pins are shortcircuited by a relay when the current is higher then 3 amps with wich it is
possible to command a second party, such as: rotative table, welding positioner, robot etc.
QUAD 275 AC/DC / COOLER UNIT 08
Fig. 1
1
2
3
4
5
5A
POS. 1 = Front panel control board (see figure 3 to Page 11)
POS. 1A = (*) Switch to allow the software download
POS. 1B = (*) RS232 socket for program download
POS. 2 = GAS output for TIG and TIG COLD WIRE applications
POS. 3 = 7 pins socket for remote control (**)
POS. 4 = Output socket for base material that has to be welded
(Ground)
POS. 5 = Quick release connectors for inlet (blue) and outlet (red).
For TIG and TIG COLD WIRE FEEDER applications
POS. 5A = By-Pass Tube with fast plug
Connect to the plugs (5) if not used
POS. 6 = Cooling water level indicator
POS. 7 = Refilling Water Lid
POS. 8 = Output power socket for TIG/TIG COLD WIRE torch and
ELECTRODE holder plug
POS. 9 = 3 pins socket for torch switch connection
POS. 9A = 3 pins plug for the connection torch switch
(connect to torch TIG / TIG COLD WIRE)
POS. 10 = Power Source Main Switch "ON - OFF"
QUAD AC/DC SERIES
GB
9 GB