Audi 8V0 054 630 A Manual De Montaje página 26

Only applies to Cabrio
Page 5 – Fig. 2
The buzzer -1- of the parking distance control system is fitted to the rear left loudspeaker.

Degrease the fitting location for the buzzer -1- using a suitable cleaning agent, e.g. industrial alcohol.

Use the supplied double-sided adhesive tape to mount the buzzer -1- in the passenger compartment.
Page 5 – Fig. 3

Unwind approximately 50 mm of the harness protective tape on the vehicle wiring.

Cut the vehicle's green/red wire.

Crimp one end of the green / red wire -1- in a supplied crimp connector -2-.

Crimp the free end of the green / red wire -3- and the red single wire -4- from the power supply wiring harness
together in the crimp connector -2-.

Heat-shrink over the duraseal connector -2- to seal it, using the hot air gun from the VAS 1978 wiring harness repair
set.
Page 5 – Fig. 4

Route the black single wire from the power supply wiring harness to the vehicle earthing point -arrow-.

Connect the single wire to the earthing point -arrow-.
Continue for all vehicles:

Secure the power supply and sensor wiring harnesses with cable ties to the existing wires.

Carry out the Park Distance Control system setup.
1.5 Park Distance Control system setup
Note
◆
For vehicles that have a removable towing hitch, this must be fitted during setup.
◆
To avoid errors during setup, do not use a metal wall (e.g. a garage door) and avoid shiny white walls.
◆
Do not enter the sensor detection area -A- during setup.
Page 6 – Fig. 1

To set up the Park Distance Control system reverse the vehicle until it is 50 cm from a wall.

Switch off the engine.

Switch on the ignition and engage the reverse gear.
The control unit signals the start of the learning process with a double beep.
If there is no beep after engaging reverse gear, carry out troubleshooting.

1.6 Setup Troubleshooting
A single, drawn-out tone must sound within a maximum of 100 seconds - this tone confirms that the learning
process has been completed successfully.
If the learning process is not confirmed as complete by the single, drawn-out tone within 100 seconds, you must
carry out troubleshooting.

1.6 Setup Troubleshooting

After audible confirmation of the successfully completed learning process and switching the ignition off, cut
through the blue single wire from the power supply wiring harness.

Insulate the ends of the cut single wire.
This ends the setup process.

Check the Park Distance Control system functions using the enclosed operating instructions.
If all of the Park Distance Control system functions are working correctly, complete the final installation.

1.7 Final installation
If you establish malfunctions with the Park Distance Control system, carry out troubleshooting and then setup
again.

1.6 Setup Troubleshooting
Note
Setup can be carried out again after the cut blue single wire is reconnected.
26