Final Installation - Audi 8V0 054 630 A Manual De Montaje

Control de distancia de aparcamiento original, audi a3 2012
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
1.6 Setup Troubleshooting
Note
If the fault has been found and rectified, the Park Distance Control system must be set up again.
1.5 Setting up the Park Distance Control system
If there is no tone after switching on the ignition and engaging reverse gear, check the power supply wiring, the
connections on the control unit and the reversing lamp light bulb.
Note
If the reversing lamp light bulb is defective, the power supply to the reversing lamp is cut off by the vehicle's own
control unit. A fault is indicated in the dash panel insert. In this case, the Park Distance Control system will also not
work.
Page 7 – Fig. 1
With reverse gear engaged, is the supply voltage to connector -2- 12V?
Troubleshooting as per the wiring diagram
Is the buzzer connector plug -4- connected correctly?
Is the blue single wire from the power supply wiring harness already cut? If necessary, reconnect.
If within a max. of 100 seconds after the double beep (start of the learning process) a single, drawn-out tone does
not sound to confirm the end of the learning process, check the sensor connections.
If within a max. of 100 seconds after the double beep (start of the learning process) a single, drawn-out tone does
not sound to confirm the end of the learning process, but an intermittent beep is heard instead, then the obstacle
behind the vehicle has not been detected.
Check the distance to the wall, correct as necessary, or align with another obstruction at a distance of 50 cm.

1.7 Final installation

Secure all the Park Distance Control system wires to existing wires or holders to avoid noises.
Fit the left-hand luggage compartment side trim and the luggage compartment floor mat in reverse order.
Interior bodywork tasks; Repair Group 70; door trims/padding; loading area and luggage compartment trims
Only applies to saloon:
Fit the right-hand side luggage compartment trim in the reverse order.
Interior bodywork tasks; Repair Group 70; door trims/padding; loading area and luggage compartment trims
27

Publicidad

Tabla de contenido
loading

Tabla de contenido