Switching The Telephone Muting/Attenuation; Switching The Feature Demo - Pioneer DEH-P70BT Manual De Instrucciones

Initial Settings
1 Use Multi-Control to select SW control.
SW control appears in the display.
2 Press Multi-Control to switch the rear
output setting.
Pushing Multi-Control will switch between
Rear SP :FULL (full-range speaker) and
Rear SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
# When the rear output setting is Rear SP :S/W,
you cannot change the subwoofer controller.
3 Push Multi-Control left or right to
switch the subwoofer output or nonfading
output (full-range RCA output).
Pushing Multi-Control left or right will switch
between Preout :S/W and Preout :FULL and
that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 76)
or subwoofer output (refer to Using subwoofer
output on page 75) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
All manuals and user guides at all-guides.com
! The sound is turned off or attenuated,
MUTE or ATT are displayed and no audio
adjustment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use Multi-Control to select Mute.
Mute appears in the display.
2 Press Multi-Control to switch the tele-
phone muting/attenuation.
Pressing Multi-Control will switch between
TEL ATT (attenuation) and TEL mute (muting)
and that status will be displayed.

Switching the feature demo

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1 Use Multi-Control to select
Demonstration.
Demonstration appears in the display.
2 Press Multi-Control to turn the feature
demo on.
DEMO ON appears in the display.
# To turn the feature demo off, press
Multi-Control again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demo by
pressing button 6 while this unit is turned off.
For more details, see Feature demo on page
11.
Section
15
81
En