Installing The Discharge Chute; Adding Oil To The Engine - Toro 58620 Manual Del Operador

Ocultar thumbs Ver también para 58620:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2
Installing the Discharge
Chute
Parts needed for this procedure:
1
Discharge chute
4
Screw
Procedure
Install the discharge chute to the mower deck as
shown.
1. Screw (4)
3

Adding Oil to the Engine

Parts needed for this procedure:
1
Engine oil
Procedure
Important:
If the oil level in the engine is too
low or too high and you run the engine, you may
damage the engine.
1.
Move the machine to a level surface.
2.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
3.
Wait 3 minutes for the oil to settle in the engine.
Figure 4
2. Discharge chute
4.
Wipe the dipstick clean with a clean cloth.
1. Dipstick
2. Full
5.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
6.
Read the oil level on the dipstick
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
4
through
is correct.
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
low or too high and you run the engine, you
g342810
may damage the engine.
7.
Install the dipstick into the oil-fill tube securely.
8.
Recycle the used oil properly.
6
Figure 5
3. Add
(Figure
6
until the oil level on the dipstick
If the oil level in the engine is too
g334792
5).

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido