Toro 58620 Manual Del Operador página 18

*There is residual oil in the crankcase after you drain
the oil. Do not pour the entire capacity of oil into the
crankcase. Fill the crankcase with oil as directed in
the following steps.
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
1. Dipstick
2. Full
4. Tip the machine onto its side (so that the air filter
is up) to drain the used oil from the oil-fill tube.
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick.
Figure 13
3. Add
Figure 14
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through
is correct.
•
If the oil level on the dipstick is too high,
13).
drain the excess oil until the oil level on the
dipstick is correct.
Important:
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
g334792
g334793
14
10 until the oil level on the dipstick
If the oil level in the engine is too