Filling The Fuel Tank; Adjusting The Handle Height And Angle; Performing Daily Maintenance; Adjusting The Height Of Cut - Toro 58620 Manual Del Operador

Filling the Fuel Tank

Fill the fuel tank as shown in
Adjusting the Handle
Height and Angle
1. Holding the handle with 1 hand, loosen both
handle-adjustment knobs until the ratchet teeth
are disengaged. Do not remove the knobs.
2. Adjust the handle to the desired position and
align the ratchet teeth. Ensure that both sides
are level.
3. Tighten the knobs.
1. Handle-adjustment knob
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page 12).
Figure 7.
Figure 7
Figure 8
2. Ratchet teeth
Maintenance

Adjusting the Height of Cut

You can adjust the height of cut from 38 to 76 mm
(1-1/2 to 3 inches). The recommended cutting height
for most yards is 51 mm (2 inches).
1. Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark
plug.
3. Use the L-handle wrench provided with the
g230458
machine to loosen the 2 capscrews.
4. Adjust the mower head to the desired height.
5. Tighten the capscrews.
6. Connect the spark plug.
1. Height-of-cut positions
2. Mower head
g334885 3. L-handle wrench
9
Figure 9
4. Height guide
5. Capscrews
g335100