Mower Maintenance; Replacing The Mower Line - Toro 58620 Manual Del Operador

Figure 23
1. Jam nut

Mower Maintenance

Replacing the Mower Line

Service Interval: Before each use or daily—Check
Use a 4 mm (0.155 inch diameter) mower line, with a
length of 55 cm (21-1/2 inches).
Important:
Do not allow the line lengths to vary
more than 2.5 cm (1 inch). Otherwise, the mower
head may not be balanced and vibrate during
operation.
Note:
Keep the mower line moist to extend its life,
maintain flexibility, and ease replacement. Store extra
line in water.
g337971 1. Remove the worn mower line from the line
retainer.
2. Cut new mower line to 55 cm (21-1/2 inches) or
using the length guide
A. Place 1 end of the line at 1 mark on the
shield.
B. Bend the line along the raised portion of the
shield to the second mark.
C. Cut the line at the second mark.
1. Length guide
3. Thread the ends of the new mower line through
the outer loops
4. Cross the ends over the line retainer and threat
them through the center hole.
5. Ensure that the ends of the line are even.
18
the mower lines. Replace the line
when it is half the original length.
(Figure 24) as follows:
Figure 24
(Figure 25).
g338089