Assembly; Ventilation; Connecting Heater To Lp Cylinder; Single Burner Models Only - Mi-T-M MH-0015-IM10 Manual Del Usuario

VENTILATION

For this heater, provide a minimum of 48 square inches of space by opening a window or door to provide
fresh, outside air. For additional heaters, provide more ventilation. Provide at least 3 square feet of open-
ing for ventilation per 100,000 Btu of rated operation.

ASSEMBLY

Note: Tools required: Medium phillips screwdriver
1. Place Tank Collar Bracket on top of Center Plate. Be sure Mounting Bolt Knob is on bottom as shown.
2 Insert Machine Screw into top hole using Phillips screwdriver.
3. Insert 2nd Machine screw into bottom hole. This will secure the Tank Collar Bracket to the Center Plate.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.

CONNECTING HEATER TO LP CYLINDER

Be sure to read and understand all of the Safety Information in this manual before connecting the heater
to the LP cylinder.

SINGLE BURNER MODELS ONLY

1. Be sure that the control knob on the regulator is in the
"OFF" position.
2. Line up the threads on the Fuel Connector Nut with the
threads on the LP cylinder valve. Turn Fuel Connector Nut
counterclockwise to tighten. Use a wrench to fully tighten
the nut, being careful not to overtighten.
3. Slowly open the LP cylinder valve.
4. Check all connections for leaks using a 50/50 mixture of
dishsoap and water. Any bubbles appearing show a leak.
Remove and reconnect the Connector Nut to the valve.

DOUBLE BURNER MODELS ONLY

1. Be sure that the control knob on the regulator is in the
"OFF" position.
2. Line up the slots in the tank collar bracket with the
tank collar ring and slide into place. Be sure the
mounting knob is to the outside, and tighten.
3. Line up the threads on the Fuel Connector Nut
with the threads on the LP cylinder valve. Turn Fuel
Connector Nut counterclockwise to tighten. Use a
wrench to fully tighten the nut, being careful not to
overtighten.
4. Slowly open the LP cylinder valve.
5. Check all connections for leaks using a 50/50 mixture
of dishsoap and water. Any bubbles appearing show
a leak. Remove and reconnect the Connector Nut
to the valve.
BE SURE TO READ AND UNDERSTAND ALL
OF THE SAFETY INFORMATION IN THIS
MANUAL BEFORE LIGHTING THIS HEATER.
HEATER HAS HIGH SURFACE TEMPERATURES.
BE SURE TO KEEP CHILDREN, PETS AND
CLOTHING AWAY FROM THE HEATER. BE
SURE TO KEEP BURNER AND HEATER
REGULATOR CLEAN AND FREE FROM
ANY DEBRIS. MAINTAIN SAFE DISTANCES FROM HEATER AS SHOWN.
Propane Tank Top Heaters Manual
ASSEMBLY
Ignition Hole
Safety Shut-Off
Valve Plunger
Heat Regulator Knob
Swivel
Manifold
Tip over Switch
Assembly
Machine
Screws
Fuel Connector Nut
Mounting Bolt Knob
Tank Collar Bracket
Regulator
Knob
11