Operation; Lighting Instructions; Match Light Models; To Turn Off Heater - Mi-T-M MH-0015-IM10 Manual Del Usuario

LIGHTING INSTRUCTIONS

MATCH LIGHT MODELS

1. STOP! Be sure to read all of the Safety Instructions.
2. Check that the valve on the propane cylinder is open.
3. Turn the Heater Regulator Knob clockwise to the "OFF" position.
4. Wait five (5) minutes for any gas to clear. Smell for gas around the heater, including near the floor. If you do
smell gas, STOP! Follow the Safety Instructions, and check for leaks. If there is no gas smell proceed to
the next step.
WARNING: NEVER USE A FLAME TO CHECK FOR LEAKS.
5. Turn the Heater Regulator Knob counter-clockwise to the "HI" position, and press in the Safety shut-off
Valve Plunger for five (5) seconds.
NOTE: When the heater is first connected to the gas supply, the plunger should be depressed for approximately thirty (30)
seconds to bleed any air from the hose, and release plunger.
6. Insert a lit match into the Ignition hole in the reflector, and depress plunger until the burner lights.
CAUTION: DO NOT INSERT THE LIT MATCH INTO THE AIR INLET HOLES IN THE MIXING TUBE.
7. Keep the plunger depressed for about thirty (30) seconds after the burner lights. Then release the plunger,
and if the burner stays lit, remove and extinguish the match. You will know that the burner is lit when the
mesh screen begins to glow red.
WARNING: NEVER LOOK OVER THE TOP OF THE HEATER DURING IGNITION. THE HEATER MAY
PRODUCE A SMALL PUFF OF FLAME DURING IGNITION WHICH CAN RESULT IN SERIOUS
BODILY INJURY.
8. If the Burner does not stay lit, repeat the lighting process. If the heater does not light after several attempts,
be sure you are getting fuel to the to the burner. The faint smell of gas will tell you the fuel is flowing. If not,
there may be a problem with your LP cylinder. Take it back to your local dealer for replacement.
9. Once the burner is lit, turn Regulator Control Knob to desired setting (HI, MED, LO).
10. Light both burners when maximum heat is desired. The second burner should be lit separately. Do not
attempt to light second burner off first burner. Be sure NOT to point burners at one another.

TO TURN OFF HEATER

1. Turn the valve on the LP cylinder clockwise to stop the flow of fuel.
2. Turn the Heater Regulator Knob to the "OFF" position, and wait at least fifteen (15) minutes for the heater
to cool.
3. Remove the heater from the LP cylinder by reversing the steps in Connecting Heater to LP Cylinder. Do
not store the LP cylinder with the heater still attached, or in an enclosed area.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
12

OPERATION

Propane Tank Top Heaters Manual