Adjusting The Headrest - CASUALPLAY Q-RETRAKTOR SAFE TECH FIX II Instructions

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
• The seat can be secured in the car with ISOFIX connectors and the Top Tether
(or the optional support bar) when used as Group 1.
• When used as Group 2, the seat should be fitted in the car with the 3-point safety
belt with or without the retractor of the car itself, approved according to UNECE
Regulation No. 16 or another equivalent standard. FIX connectors can also be
used if your vehicle has ISOFIX anchors.
• The original equipment must not be altered.
• After an accident the seat should be examined or replaced.
• Protect all parts of the seat from possible damage caused by the fold down
seat or door of the vehicle.
• Protect all the metal parts that come into contact with the child from sunlight.
• The harness straps should never be twisted.
• Always use the safety seat, even on short journeys and never leave the
child unattended inside the vehicle.
• Take the seat out of the car whenever it is not going to be used and keep it
out of the reach of children.
• Any luggage or other objects that may cause injury in the event of a collision
should be secured.
• We guarantee the safety of the device when it is used by the original buyer.
• It is not advisable to use second hand safety products.
• It is important that the other passengers in the vehicle also wear their seat
belts, because in the event of an accident they could get flung about and
injure the baby.
• If the seat is in the car and it is not in use, make sure it is fastened with the
Isofix connected and the Top Tether (or the optional support leg).
• Regularly check the different parts of the safety seat.
• The seat should never be used without the upholstery.
• Only the upholstery supplied by the manufacturer of the seat should be
used because it is an integral part of the product.
• You are responsible for the child's safety.
IMPORTANT: CONSULT THE VEHICLE INSTRUCTION MANUAL TO
LOCATE THE FASTENING POINTS FOR THE ISOFIX SYSTEM AND THE
TOP TETHER RING, AS WELL AS THE VEHICLES AUTHORISED FOR
INSTALLATION WITH Support leg (OPTIONAL). IF IN DOUBT CONSULT
YOUR VEHICLE DEALER.

ADJUSTING THE HEADREST

• Use the knobs on the sides to adjust the height of the headrest as required
(fig.1).
28

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Q-retraktor

Tabla de contenido