Operation Tips - Powerplay HOTROD HR230HR24PPLSEZ Instrucciones De Ensamblaje, Cuidado Y Uso

Operating Instructions
Leaving the engine running for several minutes without
using the spray gun can cause the circulating water to
reach temperatures over 120
machine will automatically discharge warm water onto the
ground to relieve pressure.
Stopping Pressure Washer
1. Release spray gun trigger. DO NOT operate spray gun
while turning off the engine.
2. Move the throttle lever on the engine to the "LOW"
(turtle) position.
3. Turn the engine power switch to the "OFF" position.
4. Point the water gun in a safe direction AWAY from
people, animals, or fragile objects then release any
excess pressure.
5. Turn OFF your connected water supply.
IMPORTANT: Do not unhook the high pressure hose
without releasing trapped water. Pressurized water can be
dangerous when released unintentionally.
o F. The pressure washing

Operation Tips

• When using detergent, fill bottle with a properly
formulated detergent-to-water ratio, following
instructions on the container.
• DO NOT use thick, gel-like detergents, as they will clog
the power washer and can cause damage.
• It is normal to hear the motor run intermittently when
the trigger is not being squeezed. The pump is priming
itself to operate when the trigger is squeezed.
• Turn off the power washer if not being used after five
minutes.
• The O-rings in the hose should be cleaned regularly
and lubricated with non-water soluble grease such as
petroleum jelly.
• Keep the spray tip cleaning wire nearby for unclogging
the tips.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs when
the impact force of the water pressure exceeds the
durability of the surface. Bare wood can be penetrated;
paint can be peeled off, etc. You can vary the force of
the power washer by adjusting:
1. The angle of the nozzle to the surface being
cleaned.
2. The distance from the nozzle to the surface
being cleaned.
• NEVER use a narrow, high-pressure stream of water on
soft surfaces.
• When cleaning windows, it is recommended to use
a minimum of 25° spray tip to protect the glass. A
0° spray tip is to concentrated of a spray and may
shatter the window. Position spray tip at a 45° angle,
approximately four to five feet away from the window.
Squeeze the trigger and vary the spray pattern and
angle until optimum cleaning efficiency is achieved.
13