Roborock S6 MaxV Manual De Usuario página 19

Installation
Using the Robot
1. Place the charging dock
Keep the Charging Dock on a level surface, flat against a wall. Connect
the power cable to the Charging Dock and place any exposed cable
into the cable slot. To ensure a better user experience of the mobile
app, place the Charging Dock in an area with good WiFi coverage.
Note:
・
Allow at least 0.5m (1.6ft) of clearance on each side, and more than 1.5m (4.9ft) in front of the
Charging Dock.
・
If the power cable hangs vertical to the ground, it may be caught by the robot, causing the Charging
Dock to be disconnected.
・
The Charging Dock indicator is on when the Charging Dock is electrified, and off when the robot is
charging.
・
Do not place the Charging Dock in places that are directly exposed to sunlight, and do not block the
Location Beacon. Otherwise the robot may not be able to automatically return to the Charging Dock.
・
Use double-sided tape to stick the Charging Dock down.
> 0.5m
> 1.5m
> 0.5m
2. Secure the charging dock with the adhesive tape.
Wipe the floor of the area where the charging dock will be placed with
a dry cloth, then stick the enclosed double-sided tape to the floor. Place
the dock onto the double-sided tape to secure it in place.
Note:
・
Use of the double-sided tape to secure the charging dock is optional.
・
When necessary, remove the double-sided adhesive tape slowly to reduce residue glue.
18
Double-sided tape