Canopy Assembly; Blade Assembly - Craftmade Swyft Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate 15 blade attachment screws/washers
in hardware pack. Hold up to blade and align
holes. Insert 3 blade attachment
screws/washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes and attach blade arm
with lock washers and blade arm screws.
Before securing screws permanently, repeat
with remaining blade arms. Securely tighten
all screws.
Note: Tighten blade arm screws twice a year.
canopy
screw
blade arm
lock washers
blade arm
screws
page 7
hanging
bracket
screw
canopy cover
blade attachment
screws/washers
blade