Automated Learning Process./Activating Code; Remote Control Operation; Testing Your Fan - Craftmade Swyft Guia De Instalacion

11. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position. Within
60 seconds of turning on the wall control, press and hold the OFF button on the wall control for 5 seconds or until
light blinks twice.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring the power,
press and hold the OFF button on the front of the handheld remote control for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the learning process is complete--see Section 13 below.

12. Remote Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
(switch not functional on handheld remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - (not applicable for this fan)
L2 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)

13. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to the
ON position. Test light and dimmer function and then test
fan speeds. Next, locate handheld remote control. Test the
light ON/OFF function by pressing the L2 button; test the
dimmer function by pressing the L2 button and holding it
down for
1 second. Test fan speeds with the different fan speed
buttons. If the wall and/or handheld remote control
operates all of the functions of the fan, battery has been
installed correctly. If the wall and/or handheld remote
control do (does) not operate all of the fan/light functions,
refer to "Troubleshooting" section to solve any issues before
contacting Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use "reverse" button to recirculate air depending
on the season.
NOTE: If the wall control/handheld remote control interferes
with other appliances, go back to the instructions in Section
11 above.
wall control
page 10
- 1 1
- 2 2
handheld
remote control
motor housing